Installation standards

Last Updated March 13, 2019

Standards for advertising materials

Each Standard
General standards	Standards for use of lighting equipment and video equipment	Those that use the outer surface of buildings, etc.
Paper, postcards, etc.	Protrude from buildings (sleeve signs, etc.)	Extruding from buildings (rooftop signs)
Advertising towers and billboards	Those that use the outer surface of trains, cars, or ships	Those that use telephone poles
Use of lampposts and other pillars	Those using bus stop signs and fire hydrant signs	Those that use arches
Standing signs	Advertising flag	Ad balloon

Please confirm restricted zone in "town development map information system i-mappy" (outside site).

If you fall under the town planning consultation district, please also check that.

1 General Standards

There is no risk of harming good landscape or scenic beauty.
Do not use materials that are prone to decay, corrosion, or damage.
The structure or installation method is not dangerous.
Do not interfere with the safety of road traffic and marine traffic.
Do not use fluorescent paints or other similar materials.

2 Standards for use of lighting equipment and video equipment

In the urbanization adjustment area, the first-class low-rise residential area, the second-class low-rise residential area, the first-class middle-high-rise residential area, and the second-class middle-high-rise residential area, blinking equipment and video equipment (still for more than 15 seconds) Excluding those that display only the screen that is stopped.) And other similar items should not be used.
When installing blinking equipment in areas other than the above, slow the blinking speed.
Do not use video equipment in the following areas.
1 A road area surrounded by a stop line just before the intersection of a road with a traffic light of four or more lanes and a line 5 meters outside the extension line.
2 Areas within 5 meters from the road area of 1

Image of an intersection

3 Buildings that use outer surfaces (wall signboards, etc.)

The total display area of advertising materials (in the case of video, the area obtained by multiplying the video display area by 4) shall be less than three-tenths of the wall.
Do not protrude from the wall (except when the protruding part from the upper end is 0.5 meters or less and less than half of the vertical length of the advertising material, etc.) 。
Do not block emergency entrances and windows or other openings where evacuation equipment is installed.
Do not display directly on the roof or roof of the building in the first-class low-rise residential area or the second-class low-rise residential area.

Wall signboard illustration

Using buildings and other structures that are easily visible to the public and the walls of underpasses, the area per piece of paper, postcards, etc. shall be less than 1 square meter, and the same thing shall not be displayed continuously .

5 Protrude from buildings (sleeve signs, etc.)

The display area per unit (in the case of video, the area obtained by multiplying the video display area by 4) shall be 50 square meters or less.
The upper end of the advertising material, etc., does not protrude upward of the wall of the building.
When protruding on the road, the protruding width from the boundary of the road shall be 1 meter or less, and the height to the lower end shall be 2.5 meters or more from the road surface in the case of a sidewalk, and 4.5 meters or more from the road surface in the case of a road.

Sleeve signboard illustration

6 Protrude from buildings (rooftop signs, etc.)

Do not protrude from the side of the building.
Do not display or install in the first-class low-rise residential area or the second-class low-rise residential area.
Areas other than the first-class low-rise residential area and the second-class low-rise residential area must conform to the standards in the following table.

Standards for rooftop signboards
Restricted areas	Standards per unit
Urbanization adjustment area Class 1 Middle- and High-rise Residential Areas	Height of advertising materials: 7 meters or less and less than half of the height of the building Display area: 50 square meters or less
Class 2 Mid- and High-rise Residential Area	Height of advertising materials: 7 meters or less and less than half of the height of the building Display area: Less than 100 square meters
Class 1 Residential Areas	Height of advertising materials: Less than 10 meters and less than half of the height of the building Display area: Less than 100 square meters
Type 2 Residential Area	Height of advertising materials: Less than 10 meters and less than half of the height of the building Display area: Less than 150 square meters
Quasi-residential area	Advertisement height is 10 meters or less and less than half of the height of the building Display area: Less than 200 square meters
Other Areas	Advertisement height is 20 meters or less and less than two-thirds of the height of the building Display area: Image display area is less than 100 square meters

In the table above, "installation height" refers to the height from the ground to the lower end of advertising materials. However, in the case of advertising materials, etc. that are displayed and installed on the rooftop of staircases, elevator towers, and similar buildings where the total area of the part is less than one-eighth of the building area, Including the height of the part.
In the case of video, the area obtained by multiplying the video display area by 4 is referred to as “display area”.

Please confirm restricted zone in "town development map information system i-mappy" (outside site).

7 Advertising towers and billboards

（１） Advertisement boards added to the shed of the bus stop
The display area shall be 3 square meters or less per surface.

（２） Other advertising towers and billboards other than the above

It must be installed on the ground.
The distance between the adjacent advertising towers, etc. shall be at least 1 meter. However, this does not apply if the total display area with private outdoor advertising materials, outdoor advertising materials for management, adjacent advertising towers, etc. conforms to the standards for each region.
Comply with the criteria in the following table.

Standards for billboards and billboards
Restricted areas	Standards per unit
Class 1 and Class 2 Low-rise, Middle- and High-rise Residential Areas Urbanization adjustment area	Height: Less than 10 meters Display area: 25 square meters or less
Class 1 and Class 2 Residential Areas Semi-Resident Areas	Height of less than 13 meters Display area: 50 square meters or less
Other Areas	Height: Less than 15 meters Display area: 75 square meters or less

Restricted areas"Town Development Map Information System i-Mappy" (outside site) Please check it out.

8 Trains, cars (excluding cars as advertising vehicles) or outer surfaces of ships

When displaying advertising materials using the outer surface of the train, the total area of advertising materials displayed on the outer surface of one vehicle on the train shall be less than 1/10 of the outer surface area.
The total area of advertising materials displayed using cars (excluding shared cars (excluding shared cars on regular routes)) or the outer surface of the ship shall be the outer surface of the outer surface (the bottom surface and the shallowest draft of the ship). Excluding the outer surface under the draft line.)) 1/10 or 5 square meters or less of the area.
The upper limit of the total area of advertising materials displayed using the outer surface of a shared car (limited to shared cars on regular routes) is 1/10 of the area of the outer surface (excluding the front and bottom). Or 5 square meters, whichever is larger, will not be displayed on the front of the car body.
Regardless of the above provisions, it is not this limit about thing which the mayor specifically admits.　・・・To the application procedure page

9 Those using telephone poles

Do not display it directly.
For each pillar, the number of items to be wrapped and advertisements other than wrapping (hereinafter referred to as "advertisement advertisements with telephone poles") shall be one or less each, and in principle, the position and standards shall be unified.
Wrapped items should be displayed and installed in a range from 1.2 meters to 3 meters above the ground.
Advertisements for utility poles shall be 1.2 meters or less in height and 0.5 meters or less in width, and the width from utility poles shall be 0.6 meters or less.
When protruding on the road, in principle, install it on the opposite side of the center of the road.
The lower end of the advertising material when protruding on the road shall be at least 2.5 meters from the road surface on the sidewalk, and at least 4.5 meters from the road surface for roads (including roads with no distinction between sidewalks and roads). thing.

Image of telephone pole advertising

10 Use of streetlight poles and other pillars

Do not display it directly. However, this does not apply when displaying the owner of the streetlight column, the name of the manager, etc.
Wrapped items should be displayed and installed in a range from 1.2 meters to 3 meters above the ground.
In advertising curtains and other similar things, the display area per page shall be 2 square meters or less.
Advertisements other than the above shall be 1.2 meters in height and 0.5 meters in width, and the width from streetlights shall be 0.6 meters or less.
When protruding on the road, in principle, install it on the opposite side of the center of the road.
The lower end of the advertising material when protruding on the road shall be at least 2.5 meters from the road surface on the sidewalk, and at least 4.5 meters from the road surface for roads (including roads with no distinction between sidewalks and roads). thing.

11 Use bus stop signs and fire hydrant signs

（１） Those that use bus stop signs

The total display area shall be less than half of the display area of the sign.

（２） Those that use fire hydrant signs

0.4 meters or less in height and 0.8 meters or less in width.
The lower end of the advertising material when protruding on the road shall be at least 2.5 meters from the road surface on the sidewalk, and at least 4.5 meters from the road surface for roads (including roads with no distinction between sidewalks and roads). thing.

12 Those that use arches

The lower end of the advertising material when protruding on the road shall be at least 2.5 meters from the road surface on the sidewalk, and at least 4.5 meters from the road surface for roads (including roads with no distinction between sidewalks and roads). thing.